In order to carry out this exercise, use the ULP-Triple Cable.

Plug the connector of the triple cable into its receptable:

• grab the cable connector such that the screw points down.
• plug the connector into its receptable, the connection should be smooth and easy.
• grap the collar, push it forward und turn it to the right until it stops.
• the whole connection should now be solid.

If you want to influence a point on your right side of the body, proceed as follows:

• Attach the red-marked wire to a self-adhesive electrode and place it on the point you wish to influence.
• Attach the blue-marked wire to a self-adhesive electrode and place it on the same point of the opposite side of the body.

If you want to influence a point on your left side of the body, proceed as follows:

• Attach the blue-marked wire to a self-adhesive electrode and place it on the point you wish to influence.
• Attach the red-marked wire to a self-adhesive electrode and place it on the same point of the opposite side of the body.

Attach the third wire to a self-adhesive electrode on the neck.

Turn on the instrument by moving the power switch in the back of the instrument to the position "I". Read the values from the LCD-Displays

Interpret the Readings:    

• Values in the minus region show activity.
• The higher the value in the plus region, the lower the activity or energy level at the measurement point, which will reduce pain sensitivity.

Start with visualizations. Should you desire to withdraw energy from any particular point in the body, try to decrease the values in the minus region and move them into the plus region as much as possible.

Aim of the Training:

• Try to get your readings into the plus region as much as possible, in order to decrease your energy level in the measurement region and as a result reduce the sensation of pain.